Accutire MS-5010 Heavy Duty Dial Tire Gauge
15
Aug/099
Aug/099
This heavy duty dial gauge is a joy to use with a easy to read scale and a 10 inch flexible hose to access hard to reach valves. The bleed valve allows you to over fill the tire and then bled it down to exactly the pressure you want.
Incoming search terms:
Comments (9)
Trackbacks (0) ( subscribe to comments on this post )
Leave a comment
No trackbacks yet.
Improve the web with Nofollow Reciprocity.
5:48 am on September 27th, 2009
5.0 out of 5 stars
Excellent Product!
This is the best quality tire pressure gauge I’ve ever purchased. It’s heavy duty, and the gauge holds the pressure reading until I press the release button just below the gauge…
12:02 pm on September 27th, 2009
4.0 out of 5 stars
works well
great product.it is easy to use.you can concentrate on placing end piece over the valve stem then see your reading.
6:07 pm on September 27th, 2009
2.0 out of 5 stars
No QA controls
The first unit received was defective, Amazon replaced it free of charge with a functioning one. This one seems to be working fine.
8:43 pm on September 27th, 2009
1.0 out of 5 stars
defective unit
Measurement is stuck at 30 psi maximum. Product is poorly tested before shipping.
10:24 pm on September 27th, 2009
1.0 out of 5 stars
Avoid this Product
This tire guage was inaccurate. I tried three of them, compared them to three different tire guages which gave the same reading (within 1/2 pound), and they were off by as much…
3:33 am on September 28th, 2009
3.0 out of 5 stars
Hmmmm!
The first one I received was assembled incorrectly, and let the air out of my tire. Amazon should get five stars for service, they replaced it before I had a chance to mail the…
10:53 am on September 28th, 2009
5.0 out of 5 stars
tire guage
I like this better than any gauge I have previously had because of the extra length of tubing from the gauge to the tire…
6:29 pm on September 28th, 2009
1.0 out of 5 stars
Inaccurate measurements
It turns out the tool gives inaccurate measurements of the tire pressure. I used three different tools and this one was way over on PSI measurement. Junk.
6:37 pm on September 28th, 2009
1.0 out of 5 stars
Defective Gauge
I think Accutire makes good products but their QC was lacking on this one. The needle is on the wrong side of the gauge pin so you can’t get a reading.